Currie Enterprise LP60 Low Pinion Rear Axle with Gears & Locker (Wrangler JK 2007-2018)

Currie Enterprise LP60 Low Pinion Rear Axle with Gears & Locker (Wrangler JK 2007-2018)

** PLEASE ALLOW A LEAD TIME OF 12-16+ WEEKS FOR PRODUCTION AND SHIPPING DEPENDING ON DEMAND. FEEL FREE TO CONTACT US PRIOR TO ORDERING FOR A CHECK ON INVENTORY **

The Currie LP60 rear axle for the Jeep Wrangler JK/JKU is the perfect direct bolt-in upgrade for multi-purpose commuters, Overlanders, and tow vehicles that also see off-road use. The LP60 features efficient low-pinion 60 gears, large 3.5-inch diameter axle tubes, and 40-spline axles to provide a massive upgrade in strength and reliability over the stock JK rear axle assembly. Additionally, the LP60 retains the factory wheel bolt pattern so that you can keep those nice wheels.

The Currie LP60 low-pinion rear axle for the 2007 and newer Wrangler JK/JKU is a direct bolt-in axle assembly with all required brackets and mounts in place. The vehicle's factory brakes will be retained and installed on the new LP60 axle. The factory driveshaft will require modification or replacement to accommodate the larger 60 series housing and 1350 series u-joint.

Kit Includes:
- Rear axle assembly

• Direct Bolt-in Fit for Wrangler JK/JKU
• Factory 65.375-Inch Width
• Heavy-Duty Low-Pinion Cast Center Section
• 3.5 x .375-inch Axle Tubes are Twice the Strength of the Stock Tubes
• Currie Extreme 40-Spline Axles
• Currie Heavy-Gauge Laser Cut Brackets
• Pinion Angle Optimized for Stock Height up to 4" of Lift
• Currie Rock-Proof Nodular Iron Differential Cover
• Upgraded 1350 Pinion Yoke
• Satin Black Powder Coat for Long Lasting Protection
• Retains Stock 5x5” Wheel Bolt Pattern
• Retains the Factory JK Rear Brake Components
• Center Section - Currie LP60 nodular Iron low-pinion center section
• Gear Set -Standard Dana 60™ low-pinion
• Pinion Yoke - 1350 u-joint
• Differential Cover -Currie nodular-iron cover with gasketed fill plug with dipstick, Red
• Axle Tubes - 3.5 in. diameter, .375 in. wall DOM tube
• Axle Bearings - Set 80 tapered roller bearing
• Axles - Currie Performance semi-floating, 40-spline (1.7” diameter) axles with tone rings installed for ABS/ESP retention
• Brake Rotors - Not included, reuses the stock JK rear rotors
• Brake Calipers - Not included, reuses the stock JK rear calipers
• Suspension Brackets - Heavy gauge 3/16” steel mounting brackets
• Geometry - Optimized for stock height up to 4” of lift
• Width - 65.375 inches between wheel mounting surfaces (stock JK width)
• Wheel Bolt Pattern - 5 on 5 inch with 1/2 inch studs (standard JK pattern)
• Finish - Black satin powder coat

Fits:
Jeep Wrangler JK 2 Door (2007-2018)
Jeep Wrangler JK 4 Door Unlimited (2007-2018)