APEX Designs AutoLYNX Sway Bar Disconnects | 8" Stroke (Wrangler JK, JL & Gladiator JT 2007+)

APEX Designs AutoLYNX Sway Bar Disconnects | 8" Stroke (Wrangler JK, JL & Gladiator JT 2007+)

As an innovative company, we want to make products that stand out by fixing known issues that are an irritation for the off-roader.

The patent-pending autoLYNX was designed to make disconnecting the sway bar much faster and easier:

• No need to fight a stuck QD link.
• No need to find perfectly flat ground to connect or reconnect.
• To disconnect the sway bar, just hop out and turn the knob a quarter turn and then do the other side. Takes less than 10 seconds. It’s easy to turn and that's it. Hop back in and drive.

To reconnect, turn the knobs back to the lock position and push the sway bar down until you hear a “click” and that's it. Only one side needs to be pushed down to latch. As you drive, it will automatically latch the other side. Your Jeep can be at full articulation to re-latch the bar.

• No need to park the bar or clean the mounting pins.
• No need to find level ground.
• No need to push and pull under a muddy Jeep.

You can do this on relatively un-flat ground up to 4" of articulation.

• 8" stroke
• For use with factory shocks including Rubicon, Sport and Sahara models
• It's an ideal fit for a Mojave when you're keeping your stock shocks, even when lifted. This shorter link will make mounting easier on stock-2" lifts. Typically no trimming required on factory wheel wells

Notes:
** Do not use with longer than 8.5" stroke shocks

Fits:
Jeep Wrangler JK 2 Door (2007-2018)
Jeep Wrangler JK 4 Door Unlimited (2007-2018)
Jeep Wrangler JL 2 Door (2018+)
Jeep Wrangler JL 4 Door Unlimited (2018+)
Jeep Gladiator JT (2020+)